Can a Herding Ball Be Punctured? What Happens and What to Do

Close-up of the CollieBall inner ball needle valve

It is the first question most people ask before buying, and the one we would rather answer properly than with a slogan: can a herding ball be punctured? Yes. Any inflatable can. The useful questions are how often, what causes it, what happens next, and what it costs you when it does.

No ball is indestructible, including ours

We say this on every page because it is true. A fabric-covered inflatable is chew-resistant by design, not chew-proof by claim. Give a determined dog enough unsupervised time and the wrong size, and most things lose. What we can do is build the ball so that the part most likely to wear out is the cheapest, easiest part to replace, and make sure the expensive part takes the punishment it was built for.

How the ball is built to take teeth

A CollieBall is two parts. An inflatable inner ball holds the air. A ballistic fabric cover goes over it: a ripstop weave, double stitched, closed with a double zipper that is sewn into the cover and tucked away so there is no pull tab for a dog to work at. The cover is what meets teeth, claws, gravel and fence posts. The inner ball sits inside and, when the size is right, is not what the dog gets hold of. Our page on how the original herding ball is built goes through each part.

Tooth marks on the cover after a session with a working-line dog are normal. They are not a sign the ball is wearing out. The cover is doing exactly what it is there for.

Where a herding ball actually wears

In practice the ball ends up needing attention in one of two places, and the cover is rarely the first.

The inner ball loses air. This is the usual one. Over months of daily pushing, any inflatable loses some air through the valve and the material. That is normal use rather than a fault, and a hand pump fixes it in a minute. If the inner ball stops holding air altogether, it is the part that gets replaced.

The dog gets a grip on it. This is the one that does real damage, and it almost always comes back to size. A ball that fits the jaw turns a herding session into a chew contest, and no cover holds up to that for long. A ball the dog cannot close her mouth on gets pushed, not bitten. Size is the biggest lever on how long the ball lasts, more than the fabric, the zipper or the inner.

What happens when the inner ball needs replacing

With a single-skin ball, a puncture is the end. With a covered ball it is a repair. Deflate what is left, open the zipper, take the old inner ball out, put the new one in, inflate, close the zipper. The inner ball is sold on its own, and the cover carries on. Over the life of a ball that sees daily use, expect to replace the inner once or twice. That is the design working as intended.

Compare that with a gym ball, where a single tooth through the PVC means the whole thing goes in the bin. Our article on whether a gym ball can do the job covers that trade-off in detail.

Why size decides almost everything

The rule is simple: the ball must be too big to pick up. Measure your dog at the shoulder and use the size guide: 45 cm for dogs up to 37 cm, 55 cm for 38 to 50 cm, 75 cm for 51 to 62 cm, and 95 cm for 63 cm and above. Two refinements matter for puncture risk.

First, a dog that plays hard should go up a size within her band. Jaw width matters more than body weight. A lean Malinois has a wider gape than a heavier Aussie of similar height, which is why the big working breeds belong on the 95 cm ball, as our large-breed article explains. Second, a ball that is too small is not just short-lived, it is a hazard: pieces of a torn ball can be swallowed. Right size solves both problems at once.

How to introduce the ball so it lasts

The first week sets the pattern. A few habits from owners who get years out of a ball:

  • Inflate the ball fully from the first day, as the manual describes. A firm ball rolls true and protects the cover; a soft ball folds and gives teeth something to grip.
  • Start on grass, not tile or concrete. Roll the ball a few metres rather than throwing it.
  • Keep the first sessions to about fifteen minutes and finish while the dog is still working, not when she is exhausted and frustrated.
  • Supervise, especially with a dog that plays hard. Even the best-designed toy wears over time.
  • Check the cover and the inner ball now and then for cuts or areas where the material is breaking down, and swap the inner before it needs replacing.

Play in water and on slippery surfaces is best avoided, and on hot days a long session in direct sun is hard on the dog, whatever the ball.

So, will it survive your dog?

If the size is right and the sessions are supervised, the cover takes the teeth and the inner ball takes the air, and when the inner eventually wears out you replace one inexpensive part. If the size is wrong, no fabric on earth will save it, and we would rather tell you that now than after the first chewed seam. Start with the size guide, read whether a herding ball is worth it if you are still deciding, and when you are ready, all four sizes are in the shop with the inner ball available separately.